Connecting The E5250A Output; To Connect The E5252A Output - Agilent Technologies Agilent E5250A User Manual

WARNING
Figure 4-8
Table 4-4
Setting up Measurement Environment

Connecting the E5250A Output

Connecting the E5250A Output
This section describes how to connect the E5252A and E5255A output to connector
plate, your test fixture, and so on.
•

"To Connect the E5252A Output"

• "To Connect the E5255A Output"
Turn off the E5250A and all instruments connected to the E5250A. And do not
turn them on until the connection described in this section is completed. If you
ignore this warning, you may be exposed to dangerous voltage.
To Connect the E5252A Output
The E5252A output connector is shown in Figure 4-8. The E5250A input signal
(SMU input or AUX input) appears at the E5252A output connector as shown in
Figure 4-8 when input-output switching path is made.
E5252A Output Connector and Output Signal
Input A
SMU Force or Sense
AUX Signal line
You can easily connect the E5252A output connector to the connector plate or your
test fixture by using cables shown in Table 4-4.
E5252A Output Cable
Agilent Model No.
16494A-001
16494A-002
16494B-001
16494B-002
4-20
B
Guard
Ground
Description
Triaxial cable, 1.5m (for non-Kelvin connection)
Triaxial cable, 3m (for non-Kelvin connection)
Kelvin Triaxial cable, 1.5m (for Kelvin connection)
Kelvin Triaxial cable, 3m (for Kelvin connection)
Agilent E5250A User's Guide, Edition 11
A
B
Ground