Changing The Vfp Setup Mode - Agilent Technologies Agilent E5250A User Manual

CAUTION

Changing the VFP Setup Mode

Select the SETUP MODE softkey. The display shows the present setup conditions:
Channel Configuration mode:
Model Number of each card:
Bias Mode state of each card:
Bias Port number of each card: E5252A: 1 to 10 E5255A: not applicable
The card numbers are 1 to 4 in NORMAL configuration mode, and 0 (zero) in
AUTO configuration mode.
The following softkeys are available.
Softkey
CHANGE For changing the channel configuration mode. See next page.
CONFIG
CARDn For selecting which card to change the Bias Port and Bias Mode
(n=1 to 4) state. CARDn softkeys are displayed only in NORMAL
configuration mode. Displays the BIAS STATE, BIAS PORT and
RETURN softkeys.
Select RETURN softkey to display CARDn softkey again, so you
can select another card to change the Bias Port and Bias Mode state.
BIAS For toggling the Bias Mode ON/OFF. This softkey is displayed in
STATE AUTO configuration mode, or by selecting the CARDn softkey in
NORMAL configuration mode. See next page.
BIAS Only for the E5252A card. For selecting the Bias Port. This softkey
PORT is displayed in AUTO configuration mode, or by selecting the
CARDn softkey in NORMAL configuration mode. See next page.
MAIN For returning to VFP main menu. See next page.
MENU
If you change the VFP Setup Mode, all data is cleared from the setup memories
when you return to the VFP main menu.
Agilent E5250A User's Guide, Edition 11
Controlling the E5250A
Using Virtual Front Panel Utility
NORMAL or AUTO
E5252A or E5255A
ON or OFF
Description
5-29