Turning The Unit On; Selecting An Output Channel; Entering An Output Voltage Setting - Agilent Technologies N6700 Series User Manual

Turning the Unit On

Turning the Unit On

Selecting an Output Channel

Channel

Entering an Output Voltage Setting

Method 1 – Use the Navigation and Arrow Keys
Navigation Keys
Arrow Keys
Method 2 - Use the Voltage key to enter a value
Voltage
NOTE
28
After you have connected the line cord, turn the unit on with the
front panel power switch. The front panel display will light up after
a few seconds.
A power-on self-test occurs automatically when you turn the unit on.
This test assures you that the instrument is operational. If the self-
test fails, the Err annunciator comes on. Press the Error key to
display the list of errors on the front panel. Refer to Appendix D for
further information.
When the front panel display appears, you can use the front panel
controls to enter voltage and current values.
Press the Channel key to select the output channel that you wish to program.
Use the left and right navigation keys to navigate to the setting that you wish
to change. In the display below, channel 1's voltage setting is selected. Enter
a value using the numeric keypad. Then press Enter.
Sel
You can also use the arrow keys to adjust the value up or down. When the
output is on and the unit is operating in CV mode, the output voltage
changes immediately. Otherwise, the value will become effective when the
output is turned on.
Use the Voltage key to select the voltage entry field. In the display below,
channel 1's voltage setting is selected. Enter the desired setting using the
numeric keypad. Then press Enter.
If you make a mistake, either use the
press Back to back out of the menu, or press Meter to return to meter mode.
backspace key to delete the number,
Series N6700 User's Guide