Agilent Technologies Agilent E5250A User Manual page 288

Executing Sample Programs
HCI Measurement Program
To Execute Analysis Program
Before running the program, do the following:
1. Insert the E5250A Program Disk into the computer's disk drive.
2. Specify the mass storage device (disk drive) the program disk is inserted by
using MSI statement. For example, if the device is ":CS80,702,1", enter the
following command:
MSI ":CS80,702,1"
3. Get the SP_MUX_A program from the program disk.
GET "SP_MUX_A"
4. Eject the program disk.
5. Insert the diskette which saves test result data into the computer's disk drive.
6. Specify the directory which stores the test result data files. For example, if the
directory is /test_data, enter
Execute the SP_MUX_A program as follows:
1. Press the RUN function key on the computer. The following message is
displayed.
"Enter number of devices (default:24)"
2. Enter the number of devices to be analyzed. Default number is 24.
Then the following softkeys are displayed.
Softkey
Idlin Extract Tdc from the Idlin data for all valid devices
Gmmax Extract Tdc from the Gmmax data for all valid devices
Vtext Extract Tdc from the Vtext data for all valid devices
Vtci Extract Tdc from the Vtci data for all valid devices
All Extract Tdc for all these parameters for all valid devices
End Quit the program
Tdc is the "time to target". The SP_MUX_A program extracts Tdc from the
measurement data that was saved by SP_MUX program. Tdc is the time when
the device parameter reached its termination condition.
9-32
.
MSI "/test_data"
description
Agilent E5250A User's Guide, Edition 11