Agilent Technologies Agilent E5250A User Manual page 27

Table 1-2
Figure 1-6
WARNING
CAUTION
E5255A Input/Output Connectors
2×8 multiplexer
Block No.
Block1
Block2
Block3
E5255A BIAS INPUT Connectors and OUTPUT Connectors
Do not touch the force and guard terminals of the OUTPUT connectors while
the E5250A is turned on. Dangerous voltages up to the maximum input voltage
may be present at the OUTPUT connectors.
The maximum voltage that can be applied to any input terminal is ±200 Vdc. The
maximum current is 1 Adc at ±200 Vdc. The maximum voltage that can be applied
between input terminals is 300 Vdc. Do not apply an input signal over these limits to
the E5255A inputs. If you do, the E5255A will be damaged.
If you use a bias source that has current limit capability, set the bias source current
limit to less than 1 Adc.
Agilent E5250A User's Guide, Edition 11
Agilent E5255A Product Description
BIAS INPUT
Output Port No.
(Port No.)
BIAS1 (51) Output 1 to 8
BIAS2 (52) Output 9 to 16
BIAS3 (53) Output 17 to 24
Introduction
OUTPUT
Connector
(Location)
Left
Center
Right
1-11