Agilent Technologies Agilent E5250A User Manual page 213

Syntax
Example
:SYSTem:CPON
This command resets the specified card to the power-on state. If the parameter is
ALL, all addressable cards are reset to the power-on state. Status after this command
is shown below:
Channel Configuration:
Connection Rule:
Connection Sequence:
Bias Mode:
Bias Port:
Bias Enabled Channels:
Couple Port Mode:
Couple Port:
Card Channel Status:
Self-Test Result:
For the device reset state, see *RST.
:SYSTem:CPON card_number
Parameter
card_number
OUTPUT @Hp5250;":SYST:CPON ALL"
Agilent E5250A User's Guide, Edition 11
No Change
Free
Break Before Make
Off
• E5252A : 10
• E5255A : None
All channels (output ports) are bias enabled
Off
No Couple Ports
All relays open in present channel configuration mode
No Change
Explanation
card number:
For Auto Config mode: 0 or ALL
For Normal Config mode: 1, 2, 3, 4, or ALL
Command Reference
:SYSTem:CPON
7-45