Attaching The Control Unit To An Infusion Stand - Boston Scientific EKOS Control System 4.0 User Manual

Console
Table of Contents

Advertisement

Attaching the Control Unit to an Infusion Stand

Follow the mounting instructions below to ensure the Control Unit is securely attached to the infusion stand�
1�
Select a position to attach the Control Unit on the infusion stand� Ensure:
The infusion pumps and Control Unit are positioned as low as practical on the pole�
Access to the infusion pumps is not blocked when the Control Unit is attached�
2�
Place the pole inside the mounting bracket that is located on the back of the Control Unit (see Figure 46)�
Figure 46. Pole Inside Bracket
3�
Turn the knob clockwise until it is tight (see Figure 47)�
Figure 47. Turn Knob
4�
Ensure the Control Unit is securely attached to the pole and cannot fall off the stand (see Figure 48)�
Black (K) ∆E ≤5.0
50
CMYK/

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EKOS Control System 4.0 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

H7493959340010

Table of Contents

Save PDF