Installing The Controller - HP StorageWorks HSG80 Array Controller V8.7 Maintenance And Service Manual

Replacement Procedures for Model 2200 Enclosure Elements

Installing the Controller

Use the following steps to install the controller in a single-controller configuration.
CAUTION: Carefully align the controller in the Controller A guide rails. Misaligning the
module might damage the backplane.
ESD can easily damage the controller. Wear a snug-fitting, grounded ESD wrist strap.
IMPORTANT: Ensure the program card is not installed in the replacement controller.
1. Insert the replacement controller into the Controller A bay (see Figure 4–2, 1),
and engage the retaining levers.
2. Connect a PC or terminal to the replacement controller maintenance port.
3. Press and hold the reset button while inserting the program card into the
replacement controller.
4. Release the reset button and install the program card ESD cover.
5. From the CLI prompt, display details about the configured controller using the
following command:
SHOW THIS_CONTROLLER FULL
IMPORTANT: If the controller being installed was previously used in another subsystem,
purging the controller of the old configuration is required (refer to CONFIGURATION
RESET in the controller CLI reference guide).
6. Refer to the controller CLI reference guide to configure the controller.
7. Is the current device configuration saved on a disk drive?
• No. Manually restore the current device configuration using existing
information and the controller CLI reference guide.
• Yes. Automatically restore the configuration as follows:
IMPORTANT: In the following step, if all port buttons do not begin F
program card is inserted, continue holding the Port #6 button and then eject and
reinsert the program card.
a. Shut down the controller.
b. Press and hold the Port #6 button (see Figure 4–4, 2).
c. While continuing to hold the Port #6 button, press and release the Reset
4–6
button until the port LEDs stop flashing.
HSG80 Array Controller V8.7 Maintenance and Service Guide
when the
LASHING