Tektronix AWG7000B Series Service Manual page 73

AWG7000B and AWG7000C Series Service Manual
3. Remove the touch screen module:
a. Remove the two screws securing the touch screen module to the
front-panel bracket.
b. Disconnect the cable from J200 on the LCDA board.
c. Lift the touch screen module away from the front-panel bracket.
4. Remove the LCD module:
a. Remove the four screws securing the LCD module to the front-panel
bracket.
b. Disconnect the cable from J110 on the LCDA board.
c. Disconnect the cable from CN2 on the Inverter board.
d. Lift the LCD module away from the front-panel bracket.
5. Disassemble the front-panel assembly components, using the following figure
as a guide.
Installation. To install, reverse this procedure.
Removal and Installation Procedures
4–19