Supply Unit; Removing The Battery From The Control Enclosure Power-Supply Unit - IBM Storwize V7000 Troubleshooting And Maintenance Manual

Be careful when you are replacing the hardware components that are located in the back of the system
that you do not inadvertently disturb or remove any cables that you are not instructed to remove.
Each power supply unit in a control enclosure contains an integrated battery that is used during
temporary short-term power outages. You must replace the battery with the exact same model.
To replace the battery in the power supply unit of the control enclosure, perform the following steps:
1. Read the safety information to which "Preparing to remove and replace parts" on page 85 refers.
2. Follow the removing steps of the replacing a power-supply unit procedure. Go to "Replacing a power
supply unit for a control enclosure" on page 90.
3. Remove the battery, as shown in Figure 28.
Figure 28. Removing the battery from the control enclosure power-supply unit
a. Press the catch to release the handle 1 .
1
2
3
Chapter 8. Removing and replacing parts
97