Calibration Menu - Rice Lake IQ plus 210 Installation Manual

IQ plus 210 Installation Manual
Parameter Choices
UNITS LB
KG
OZ
G
LB/OZ
ON
LB
KG OFF
OZ
G
LB/OZ
3.2.3

Calibration Menu

See Section 4.0 on page 19
CONFIG
WZERO
*CAL*
Display and edit
zero calibration
A/D count value
Parameter Choices
WZERO —
WVAL —
WSPAN —
REZERO —
16
Visit our website
FORMAT Menu
Specifies primary units for displayed and printed weight. Values are: LB=pound; KG=kilogram; OZ=ounce;
G=gram; LB/OZ=pounds and ounces.
Alternate Units (ALTUNT Parameter)
Alternate units. Determines which units are displayed when the UNITS button is pressed. The value for the
primary unit (selected on the PRIMAR parameter) is always ON.
NOTE: The LB/OZ setting is not a Legal-for-Trade setting.
Table 3-3. Format Menu Parameters (Continued)
for calibration procedures.
XXXXXXX FORMAT CALIBR
WVAL
Display and edit
test weight value
Figure 3-8. Calibration Menu
CALIBR Menu
Level 2 submenus
Display and edit the zero calibration A/D count value.
Display and edit the test weight value.
Display and edit the span calibration A/D count value.
Press ENTER to remove an offset value from the zero and span calibrations.
Use this parameter only after WZERO and WSPAN have been set. See
tion about using this parameter.
Table 3-4. Calibration Menu Parameters
www.RiceLake.com
Description
SERIAL XXXXXXX
DIG IN DEFLT
WSPAN REZERO
*CAL*
*
Display and edit Press Enter to
span calibration remove offset from
A/D count value zero and span
calibrations
Description
VERS
CAL*
Section 4.0 on page 19 for more informa-