Table of Contents
Advertisement
3.2.4
Serial Menu
CONFIG
BAUD
9600
1200
2400
4800
Parameter
Choices
BAUD
9600
1200
2400
4800
BITS
8NONE
7EVEN
7ODD
CR/LF
TERMIN
CR
ECHO
OFF
ON
PRNFRQ
DEMAND
AUTO1
AUTO2
STREAM
XXXXXXX
FORMAT
CALIBR
BITS
TERMIN
8NONE
CR/LF
7EVEN
7ODD
Figure 3-9. Serial Menu
SERIAL Menu
Baud rate. Selects the transmission speed for the serial port.
Selects number of data bits and parity of data transmitted from the serial port.
Termination character. Selects termination character for data sent from the serial port.
This command enables or disables echoing of the serial commands sent to the indicator.
Print frequency. Specifies when the indicator sends data to the serial port:
DEMAND:When a PRINT digital input is activated or the KPRINT EDP command received.
AUTO1:Output enabled by scale in motion; transmitted when scale returns to standstill.
AUTO2:Output enabled by scale at center of zero; transmitted when a positive scale weight is at standstill.
STREAM:Continuous output. See
Weight data is sent to the serial port in displayed units except when other units are specified using one of the XGx
EDP commands (see
Section 5.0 on page
If DEMAND, AUTO1, or AUTO2, is selected for this parameter, serial output is formatted as follows:
wwwwwww uu GROSS
where wwwwww is a 7-digit weight field (leading zeroes suppressed, including decimal point and minus sign, if
required), uu is the units designator (lb, kg, oz, or G).
If pounds/ounces (LB/OZ) is specified as the primary units, the serial output is formatted as shown below:
xxx lb yyyy oz GROSS
where xxx is the three-digit pounds weight (including minus sign, if required) followed by lb and a space; and
yyyy is the four-digit ounce weight (including decimal point) followed by oz.
Table 3-5. Serial Menu Parameters
© Rice Lake Weighing Systems ● All Rights Reserved
SERIAL
XXXXXXX
DIG IN
DEFLT
ECHO
OFF
CR
ON
Description
Section 6.3 on page 27
for output format.
22).
Configuration
VERS
PRNFRQ
DEMAND
AUTO1
AUTO2
STREAM
17
Advertisement
Table of Contents
