Parameter Setting Commands - Rice Lake IQ plus 210 Installation Manual

5.1.4

Parameter Setting Commands

Parameter setting commands allow you to display or change the current value for a particular configuration parameter (Tables
5-3 through 5-8).
Current configuration parameter settings can be displayed in either setup mode or normal mode using the following syntax:
command<ENTER>
Most parameter values only can be changed in setup mode. Use the following command syntax when changing parameter
values:
command=value<ENTER>
where is a number or a parameter value. Use no spaces before or after the equal (=) sign. If you type an incorrect
value
command or value, the display reads
effect until you exit setup mode.
For example, to set the motion band parameter to 5, type the following:
MOTBAND=5D<ENTER>
Command
GRADS Graduations
ZTRKBND Zero track band
ZRANGE Zero range
MOTBAND Motion band
OVRLOAD Overload
FILTER Digital filtering
Command
PRI.DECPNT Primary units decimal position
PRI.DSPDIV Primary units display divisions
PRI.UNITS Primary units
ALT.LB Enable alternate units
ALT.KG
ALT.OZ
ALT.G
ALT.LBOZ
Command
WZERO Zero calibration
WVAL Test weight value
WSPAN Span calibration
REZERO Rezero
LC.CD Set deadload count
LC.CW Set span count
Command
EDP.BAUD Serial port baud rate
EDP.BITS Serial port data bits/parity
EDP.TERMIN Serial port termination character
EDP.ECHO Serial port echo command
PRNFREQ Print frequency
. Changes to the parameters are saved as they are entered but typically do not take
??
Description
1–10 000
OFF, 0.5D, 1D, 3D
1.9%, 100%
1D, 2D, 3D, 5D, 10D, 20D, OFF
FS+2%, FS+1D, FS+9D, FS
1, 2, 4, 8, 16, 4RT, 8RT, 16RT
Table 5-3. CONFIG EDP Commands
Description
8.88888, 88.8888, 888.888, 8888.88, 88888.8, 888888, 888880 (88 88.8 or 888 88
in LB/OZ display mode)
1D, 2D, 5D
LB, KG, OZ, G, LB/OZ
ON, OFF
Table 5-4. FORMAT EDP Commands
Description
—
test_weight_value
—
—
value
value
Table 5-5. CALIBR EDP Commands
Description
1200, 2400, 4800, 9600
8NONE, 7EVEN, 7ODD
CR/LF, CR
OFF, ON
DEMAND, AUTO1, AUTO2, STREAM
Table 5-6. SERIAL EDP Commands
© Rice Lake Weighing Systems ● All Rights Reserved
EDP Commands
Values
Values
Values
Values
23