Table of Contents
Advertisement
1.0
Introduction
This manual is intended for use by service technicians responsible for installing and servicing the IQ plus
indicator.
Configuration and calibration of the indicator can be accomplished using the indicator front panel keys, the EDP command set,
or Version 2.3 or later of the Revolution
methods.
Some procedures described in this manual require work inside the indicator enclosure. These procedures are
WARNING
to be performed by qualified service personnel only.
Manuals and additional resources are available from the Rice Lake Weighing Systems website at
Warranty information can be found on the website at
1.1
Overview
The IQ plus 210 is a single-channel digital weight indicator housed in a NEMA 4X/IP66-rated stainless steel enclosure. The
indicator front panel consists of a large (.8 in, 20 mm), six-digit, seven-segment LED display, seven LED annunciators, and two
piezo switches used to zero the scale and select the displayed units. Features include:
• Drives up to four 350load cells
• Supports 4- and 6-wire load cell connections
• Two configurable digital inputs
• Single serial port supports full duplex, RS-232 communications at up to 9600 bps
• Available in 115 VAC and 230 VAC versions
1.2
Operating Modes
The IQ plus 210 has two modes of operation:
Weigh mode
Weigh mode is the production mode of the indicator. The indicator displays the gross weight and the LED annunciators
indicate scale status and the type of weight value displayed. Once configuration is complete and a legal seal is affixed to
the back of the indicator, this is the only mode in which the IQ plus 210 can operate.
Setup mode
Most of the procedures described in this manual require the indicator to be in setup mode, including configuration and
calibration.
To enter setup mode, remove the large fillister head screw from the enclosure backplate. Insert a screwdriver or a similar
tool into the access hole and press the setup switch once. The indicator display changes to show the word
configuration utility. See
Section 3.1 on page 10
™
www.ricelake.com/warranties
© Rice Lake Weighing Systems ● All Rights Reserved
Introduction
210 digital weight
for information about configuration
www.ricelake.com
CONFIG
.
1
Advertisement
Table of Contents
