3.2
Calibration Menu
See
Section 4.0 on page 36
CONFIG
FORMAT
WZERO
Parameter
Choices
WZERO
CAL
EDIT
WVAL
—
WSPAN
CAL
EDIT
REZERO
ZERO
(flashing)
for calibration procedures.
CALIBR
PROGRM
WVAL
Figure 3-4. Calibration Menu
Do not adjust this value after WSPAN has been set;
to display ENTER then press
press
Press
to display the current captured zero mV value; the value may be edited as required;
press
to save the edited value
Press
to display the test weight value; The value may be edited as required;
press
to save the edited value
to display ENTER then press
Press
Press
to display the current captured net span mV value; the value may be edited as required;
press
to save the edited value
Press
to remove the weight of the testing apparatus like hooks or chains used during the calibration process;
always use this parameter after WZERO and WSPAN have been set to recapture a new zero value
Table 3-6. Calibration Menu Parameters
PASWRD
TEST
MENU
WSPAN
Description
to capture the zero value
to capture the net span value
© Rice Lake Weighing Systems ● All Rights Reserved
Configuration
REZERO
23