Making Labels From Paper Templates; Installing Labels In The Buttons - Extron electronics XTP II CrossPoint 1600 User Manual

4. Click the
necessary to make all of the button labels that you need.
To access the help program, click the

Making Labels from Paper Templates

Figure 86
cut them out, write button information in each button area as desired, and put them in the
windows of the input or output buttons.

Installing Labels in the Buttons

Install new labels in the front panel buttons as follows:
1. Remove the button from the matrix switcher; use a small, flat bladed screwdriver such
as an Extron Tweeker to gently pry a button out from the front panel (see figure 85).
Clear Lens
Separate the two-
piece button here at
the corner.
Figure 85.
2. Locate the notch in the corner of one side of the clear button cap lens.
3. Separate the white backing (diffuser) from the clear button cap (lens); insert the blade of
the small screwdriver into the corner notch and gently twist the blade.
4.
Save the translucent, white diffuser, but remove the text/label insert from the transparent
button cap lens.
5. Insert the replacement button label into the button cap. Check for correct label
orientation.
6. Align the white diffuser plate with the cap (lens). The bumps on the diffuser plate should
be aligned (top and bottom) with the notches on the clear button cap. Firmly snap it into
place.
7. Align the tabs on the base of the matrix switcher with the notches on the diffuser plate.
Gently, but firmly, press the reassembled button into place in the front panel of the
switcher.
8. Repeat steps 1 to 7 as needed to relabel other buttons.
XTP II CrossPoint 1600, 3200, and 6400 Switchers • Maintenance and Modifications
button and create new labels as many times as
Clear All Buttons
Help
on the next page provides strips of blank button labels. If desired, copy them or
T E
X T
Button Label
Pry the two
pieces apart.
Illuminated Button Label Replacement
menu.
Base
Diffuser
152