Extron electronics XTP II CrossPoint 1600 User Manual page 89

Arrangement of Command and Response Tables
Different board types and endpoint types accept different types of commands. There is
some repetition in the command and response tables, depending on the input and output
for which the commands are appropriate. Additionally, basic whole-switcher commands,
more advanced whole-switcher commands, and IP- and remote port setup commands are
presented in separate command and response tables.
The following pages present seven command and response tables, each defining a subset
of SIS commands and their responses, with examples where appropriate. The tables that
are presented are listed below. For increased detail as to where each command family is
presented, see table 7, on the next page and
• SIS Command and Response Table for Basic Matrix Switcher
starting on page 86 — SIS commands for basic, everyday functions of the
XTP II CrossPoint switcher frame.
• SIS Command and Response Table for Input-Board-Specific
starting on page 87 — SIS commands to control and monitor the inputs to the matrix
switcher via assorted input boards.
•
SIS Command and Response Table for Input-Endpoint-Specific
starting on page 95 — SIS commands to control and monitor the XTP T HDMI
transmitter and XTP T USW 103 switcher input endpoints from the matrix switcher.
•
SIS Command and Response Table for Output-Board-Specific
starting on page 102 — SIS commands to control and monitor the outputs from the
matrix switcher via assorted output boards.
• SIS Command and Response Table for Output-Endpoint-Specific
Commands, starting on page 106 — SIS commands to control and monitor the
XTP R HDMI receiver endpoint from the matrix switcher.
• SIS Command and Response Table for Advanced Matrix Switcher
Commands, starting on page 110 — SIS commands for advanced functions of the
XTP II CrossPoint switcher frame.
• SIS Command and Response Table for IP- and Remote Port-Specific
Commands, starting on page 117 — SIS commands to control and monitor the IP
interface and Remote RS-232/RS-422 port of the XTP II CrossPoint matrix switcher.
XTP II CrossPoint 1600, 3200, and 6400 Switchers • Programming Guide
table 8 on page 83.
Commands,
Commands,
Commands,
Commands,
81