Extron electronics XTP II CrossPoint 1600 User Manual page 68

Example 9: Viewing and adjusting an analog output volume level
In the following example, the audio output volume is viewed and adjusted. The steps show
the front panel indications that result from your action.
Because of the different volume display schemes, the output audio levels that result from
the following example are shown twice:
• As displayed on an XTP II CrossPoint 3200 or XTP II CrossPoint 6400 switcher
• As displayed on an XTP II CrossPoint 1600 switcher
The XTP II CrossPoint 3200 and XTP II CrossPoint 6400 drawings show the actions that led
up to the display. The XTP II CrossPoint 1600 drawing shows the volume display only, not
the actions that caused it.
1. Clear all selections: Press and release the
2. Select Audio mode: Press and hold the
until it blinks.
Press and hold.
AUDIO
2 seconds
3. Select an output: Press and release the
In figure 43 and figure 44, the lit or blinking input buttons indicate 41.5 percent of the
applied audio input. The unlit input buttons indicate an audio volume attenuation of 39 dB.
1 2 16
Press to light
the button.
Each lit input button beyond input 1 indicates that 3 percent of the total input volume
is applied to the output. The flashing button indicates an additional 1.5 percent.
Figure 43. Select Output 1
Figure 44 shows the same volume as figure 43, but displayed on an
XTP II CrossPoint 1600.
2
1 3 4 5
Figure 44. Volume Display on an XTP II CrossPoint 1600 Switcher
NOTE: Volume is protected when front panel Lock mode 2 is selected. You can
view the volume in Lock mode 2 but you cannot change it from the front panel
(see Setting the Front Panel Locks (Executive Modes)
If front panel Lock mode 2 is selected and you try to perform step 4, the actions
are ignored and the
XTP II CrossPoint 1600, 3200, and 6400 Switchers • Operation
button.
Esc
button for approximately 2 seconds
Audio
AUDIO
Output 1
1 2 3
17 18 19 27 28 29 30 31 32
39 dB attenuation,
41.5% volume
INPUTS
6 7
8 9 10 11 12
, , and
Enter Video Audio
button (see figure 43).
39 dB attenuation
41.5% volume
INPUTS
1 12 13 14 15 16
13 14 15 16
on page 62).
buttons blink.
60