Features - Extron electronics XTP II CrossPoint 1600 User Manual

Analog audio inputs
Boards listed in
input captive screw connectors for balanced or unbalanced 2-channel audio. These boards
can perform analog-to-digital conversion of analog audio inputs for audio breakaway ties.
Analog audio input levels can be adjusted through a range of +24 dB gain through –18 dB
attenuation.
Analog audio outputs
Boards listed in
captive screw connectors for balanced or unbalanced 2-channel audio. These boards
extract 2-channel audio from the embedded stream for analog audio outputs with mute and
audio volume controls.

Features

Available in I/O sizes from 4x4 to 64x64 — System configuration is flexible to match a
wide variety of small to large-sized installations.
50 Gbps digital backplane supports 4K video and beyond — Exceeds the data-rate
requirements of the highest resolution video formats, including 4K/60 with 4:4:4 chroma
sampling at 16 bits per color. Ensures switching and distribution of video signals without
degradation, offering the performance required to maintain signal integrity with the most
demanding 4K video requirements.
Compatible with all XTP integrated system products — XTP II CrossPoint is a flexible,
reliable signal switching and distribution system that provides a completely integrated
solution for multiple digital and analog formats.
Fully digital signal routing — Analog signals are digitized, sending a reliable, high quality
digital video signal to the output destination.
Wide selection of input and output boards — Boards provide integration for a variety
of signal types and formats, ensuring system customization appropriate for a wide range of
applications.
Serial port insertion from the Ethernet control port — System level device control to
all remote locations via the Ethernet port of the matrix switcher, providing comprehensive
control of endpoints and attached devices without needing additional cabling.
Remote power to XTP transmitters and receivers — To simplify installation in space-
challenged locations, an XTP II CrossPoint matrix switcher can provide power to remote
XTP transmitters and receivers over the same STP cable that is used for sending AV signals.
This avoids the need for external power supplies at remote endpoints.
HDMI 2.0, 1.4, or 1.3 compatible, depending on the I/O board installed — Supports
HDMI specification features, including data rates up to 6.75 Gbps, Deep Color up to 12-bit,
3D formats, Lip Sync, and HD lossless audio formats.
HDCP compliant up to HDCP 2.2 (depending upon the I/O board installed) — Ensures
display of content-protected media and interoperability with other HDCP-compliant devices.
HDCP authentication and signal confirmation via RS-232 or Ethernet —
The XTP II CrossPoint switcher provides real-time verification of HDCP status for each digital
video input and output. This allows for simple, quick, and easy signal and HDCP verification
through RS-232/RS-422 or Ethernet, providing valuable feedback to a system operator or
helpdesk support staff.
HDCP Visual Confirmation provides a green signal when encrypted content is sent
to a non-compliant display — A full-screen green signal is sent when HDCP-encrypted
content is transmitted to a non-HDCP compliant display, providing immediate visual
confirmation that protected content cannot be viewed on the display.
table 2 on page 4 as supporting analog audio input have four stereo audio
table 2 as supporting analog audio output have four stereo audio output
XTP II CrossPoint 1600, 3200, and 6400 Switchers • Introduction 7