Muting and Unmuting Video and Audio Outputs
Individual outputs can be muted or unmuted as follows:
NOTE: Output mutes are protected when front panel Lock mode 2 is selected. You
can view the status of the output (muted or unmuted) in Lock mode 2 but you cannot
change it from the front panel (see
Modes)
1.
Press the
control button indications that may be on.
2.
Press and release the
3.
Select video, audio, or both to mute or unmute by pressing the
Audio
4.
One at a time, press and hold the buttons for the desired outputs for approximately
2 seconds. The output buttons for the selected outputs blink to indicate the mute or
return to their previous state to indicate the unmute.
5.
Press and release the
NOTES:
•
•
•
on page 62).
button to clear any input button indications, output button indications, or
Esc
button.
View
button.
button to return to normal switcher operation.
View
You can mute video and audio, video-only, or audio-only outputs. Pressing and
releasing the
button and the
Video
and off.
When you enter View-only mode, the output buttons turn on for all outputs
without ties.
Mutes are saved to non-volatile memory. When power is removed and restored,
the mute settings are retained.
XTP II CrossPoint 1600, 3200, and 6400 Switchers • Operation
Setting the Front Panel Locks (Executive
button toggles each selection on
Audio
button and the
Video
49