Mounting Instructions; Battery And Power Precautions; Removing And Installing An Input Or Output Board Or Blank Panel; Removing An Input Or Output Board Or Blank Panel - Extron electronics XTP II CrossPoint 1600 User Manual

Mounting Instructions

If desired, rack mount the switcher as follows:
1.
2.

Battery and Power Precautions

The switchers are each provided with a permanently installed (factory-soldered in place)
lithium battery. The battery maintains the real time clock in the event of power failure or
extended storage periods and does not affect the normal operation of the switcher. If the
battery becomes ineffective, return the switcher to Extron for repair.
WARNING:
AVERTISSEMENT : Si la pile est mal remplacée, il y a un risque d'explosion. N'essayez

Removing and Installing an Input or Output Board or Blank Panel

Circuit boards can be replaced for fault correction. They can be added or removed to
increase or decrease the Input or output configuration (size) of the XTP II CrossPoint
switcher.
ATTENTION:
NOTES:

Removing an Input or Output Board or Blank Panel

Remove an Input or output board or blank panel as follows:
1.
2.
3.
4.
Insert the unit into the rack, aligning the mounting bracket holes with those in the rack.
Secure the switcher to the rack using the supplied bolts.
There is a danger of explosion if the battery is incorrectly replaced. Do not
attempt to remove or replace the internal battery.
pas de retirer ou de remplacer la batterie interne.
• Do not touch the electronic components or the backplane or circuit board
connectors without being electrically grounded. Handle circuit boards by their
edges only. ESD can damage circuits, even if you cannot feel, see, or hear it.
• Ne pas toucher les composants électroniques ou les connecteurs sur la carte mère
ou sur les circuits imprimés sans être électriquement relié à la terre. Manipuler les
circuits imprimés en les tenant seulement par leurs bords. ESD peuvent
endommager l'équipement, même si vous ne pouvez pas le sentir, le voir ou
l'entendre.
• For proper cooling and air flow, boards or blank panels should be installed in all
locations during normal switcher operations.
• The Input and output boards are hot-swappable. You do not need to power down
the switcher to remove or install an input or output board.
For an input or output board, disconnect any connected cables.
Rotate the top and bottom (XTP II CrossPoint 3200 or XTP II CrossPoint 6400) or left
and right (XTP II CrossPoint 1600) knurled knobs (see
completely loosen the screws.
Gently pull on the screws to loosen the board or panel from the backplane.
Slide the board or panel out of the chassis and place it on an anti-static surface or in an
anti-static container.
XTP II CrossPoint 1600, 3200, and 6400 Switchers • Maintenance and Modifications
figure 75 on the next page) to
144