Basic Setup With Configuration Bar Codes; Reset Factory Defaults - Intermec SG20B User Manual

Chapter 4 — Configuring the Scanner and Base Station as a System

Basic Setup with Configuration Bar Codes

Reset Factory Defaults

40
This section provides you with configuration bar codes for a basic
setup. For more configuration options, use EasySet (see
"Configuring Your System with EasySet" on page
All default values are marked with (*).
For a same setup, configuration bar codes can be different depending
on whether they apply to the scanner or to the SG20 Bluetooth Base
Station. This is indicated in the configuration bar code title
("Scanner" or "Base Station"). For example to reset your scanner to
the factory default settings, you will need to scan the "Reset factory
defaults - Scanner" configuration bar code; for the base station, scan
the "Reset factory defaults - Base station" configuration bar code.
Note: It is recommended that your SG20B scanner has established a
Bluetooth connection with a SG20 Bluetooth Base Station (see
"Connecting the SG20B Scanner to a SG20 Bluetooth Base
Station" on page 34) prior to reading configuration bar codes.
You can reset the factory defaults of the scanner or of the base station.
When resetting your scanner, the Bluetooth connection is lost. Make
sure you establish a Bluetooth connection again before trying to read
bar codes.
Reset factory defaults - Scanner
SG20B Cordless Scanner + Bluetooth Base Station User's Guide
47).
Reset factory defaults - Base station