Install / Setup - Intermec CN70 Manual

Install / Setup

The Intermec CN70 is a Plug-N-Play device. The Intermec device driver is
automatically installed from the device once connected to a PC (this driver must be
installed automatically once the device is connected to the PC and is not available
for download via the internet). In addition to the Intermec driver, Microsoft
Windows Mobile device drivers must also be installed. Ensure PC is connected to
the internet then obtain these drivers automatically. Windows Vista, 7, and 8 OS
users must first download and install (or update) the "Windows Mobile Device
Center" application. Proceed with the following once the "Windows Mobile Device
Center" application is installed. Note: Reference the
Troubleshooting tips" section of this guide for PC's installed with the Windows XP
operating system.
1.
Connect power cord from Intermec CN70 dock to power outlet.
2.
Connect USB cable from Intermec CN70 dock to PC.
3.
Insert the battery into the CN70 scanner and wait until the scanner fully
boots.
4.
Use the stylus wand to select/open the time/date clock on the scanner's
desktop and correctly set the date/time. Tip: This can also be accomplished
automatically once the device is "synced".
5.
Firmly seat the scanner onto the dock.
6.
Once the scanner is seated, the scanner drivers will automatically install.
Once the install is successful, a notification will be displayed on the PC's
desktop. Also, once "Window Mobile Device Center" is fully setup/configured
then it will automatically open and connect the scanner to the PC. This
process may take several minutes. Note: The person installing the device
must possess administrator rights on the PC to perform this action.
A product of GRA, Inc. www.grainc.net
CN70 Barcode Scanner
"Intermec CN70
Knowledge Guide
1 of 25