Intermec EasyCoder F2 Installation And Operation Manual page 22

Media Com-
partment, cont'd.
Warning:
If the hanger is fitted in its up-
per position, the screw will
interfere with a small (38 mm/
1.5") core causing paper mis-
alignment.
Intermec EasyCoder F2 – Installation & Operation Ed. 1
Paper Supply Positions
There are four sets of threaded holes and slots in the printer's cen-
tre-line wall for the paper supply spool or the paper supply hanger
so as to allow the largest possible roll size given the limitations of
the rewind unit and/or the full enclosure provided by the long side
door. The positions are indicated by numbers engraved in the cen-
tre-line wall
• Position 1 is used when the paper compartment is fully enclosed
by a long side door, regardless of the existence of a rewinder
Maximum roll size is 152 mm (6").
• Position 2 is used in connection with a short side door that only
encloses the print unit, but without any rewinder. Maximum roll
size is 213 mm (8.38").
• Position 3 is used in connection with a short side door and an
optional rewind unit. Maximum roll size is 203 mm (8").
• Position 4 is reserved for future development.
The printer can also use an external paper supply located behind the
paper compartment.
The position of the paper supply spool is not intended to be changed
by the operator.
To move the hanger, remove the screw, twist the hanger a quarter of
a turn and pull it out. To insert it into another slot, rotate it a quarter
of a turn and twist back so the lips engage the cut-outs in the sides
of the slot. Move it up (3" core) or down (1.5" core) as far as it goes
and secure it with the screw.
Chapter 3 Installation
Pos. 3
Pos. 2
Pos. 1
(Pos. 4)
21