Intermec EasyCoder F2 Installation And Operation Manual page 11

Introduction,
cont'd.
Intermec EasyCoder F2 – Installation & Operation Ed. 1
Setup
By default, the printer is set up for the following communication
protocol:
Baudrate ............................. :
Character length ................. :
Parity .................................. :
Stop bits ............................. :
Flowcontrol ........................ :
New line ............................. :
If you want to change any of these values, please refer to chapter 7
"Setup Mode".
Set up the terminal or host computer for the same communication
protocol as the printer.
Paper Supply
Load the printer with labels with a width of at least 35 mm (1.4")
and a length of at least 40 mm (1.6"), see chapter 5.
If the printout becomes too light or dark, you will need to change
the paper type setup, see chapter 7 "Setup Mode".
Startup and Communications Check
Turn on the printer. Provided the printer is not fitted with any cus-
tom-made startup program, after initialization the display will show
the Intermec Shell countdown menu:
ENTER=SHELL
5 sec. v.4.3
4 sec.
3 sec.
2 sec.
1 sec .
Do not take any action. By default, the display window will show
the following message when the countdown is completed, e.g.:
Fingerprint
7.2
If the display does not show this message, refer to chapter 8 "Inter-
mec Shell Startup Program" and select the "Fingerprint" applica-
tion.
Chapter 2
9600
8
none
1
none
CR/LF
v.4.3
v.4.3
v.4.3
v.4.3
Print a Label
10