Safety Requirements; Product Labelling - Intermec EasyCoder F2 Installation And Operation Manual

Safety
Requirements

Product Labelling

Intermec EasyCoder F2 – Installation & Operation Ed. 1
Intermec assumes no responsibility as regards fulfilling the CE Di-
rective if the printer is handled, modified or installed in any way
other than that described in Intermec's manuals.
Caution
• Read this manual carefully before connecting the printer.
• Moving parts are exposed when the side door is open, so ensure
that the door is closed before you operate the printer.
• Do not open the front/left-hand cover. Dangerous voltage!
• Do not remove the bottom plate. Dangerous voltage!
• Do not put your fingers inside the print mechanism when the
power is on.
• Place the printer on an even surface which can support its weight
of approximately 5.5 kgs (12 lbs) plus supplies.
• Do not spray the printer with water. If using a hose to clean the
premises in an industrial environment, remove the printer or
protect it carefully from spray and moisture.
• Carefully read the warning text on the envelope before using a
cleaning card.
The machine sign is attached to the printer's rear plate and contains
information on type, model and serial number as well as mains volt-
age. It also contains various signs of approval.
Chapter 1 Introduction
8