Side Doors; Rewind Unit; 3" Adapter; Quick-Load Guides - Intermec EasyCoder F2 Installation And Operation Manual

Side Doors

Rewind Unit

3" Adapter

Quick-Load
Guides
Label-Taken
Sensor
Intermec EasyCoder F2 – Installation & Operation Ed. 1
The EasyCoder F2 comes with either a short side door, that only
covers the print unit, or with a long side door, that encloses the
entire paper compartment. The long side door has a slot for external
paper supply. The long side door is generally illustrated throughout
this manual, but pictures of the short side door can be found at the
start of this chapter and in chapter 5 "Paper Load/Quick-Load".
The rewind unit is an optional device for peel-off operation, i.e. the
labels are separated from a backing paper (liner) after printing and
the backing paper is wound up on an internal spool. The rewind kit
also includes a guide shaft.
Rewinding cannot be combined with Quick-load guides, see be-
low.
The 3 inch/76 mm adapter is included in each delivery of the Easy-
Coder F2 models with a paper supply roll and makes it possible to
use paper rolls with 3 inch/76 mm inner diameter paper cores.
The adapter is pressed onto the paper supply spool and held in place
by a screw
The 3" adapter is not used in connection with a paper hanger.
For Quick-Load operation (see chapter 5 "Paper Load"), a set of
paper guides is fitted at the rear of the print unit instead of the stand-
ard guide ring. The outer guide is adjustable for different paper
widths.
The Label-Taken Sensor (LTS) is a photoelectric sensor, which ena-
bles the printer's firmware to detect if the latest printed label, ticket,
tag etc. has been removed before printing another copy.
The LTS can be enabled or disabled by means of the instructions
LTS& ON and LTS& OFF respectively in Intermec Fingerprint and
the Intermec Direct Protocol.
Chapter 9 Options
71