Printhead Pressure - Intermec EasyCoder F2 Installation And Operation Manual

Printhead
Pressure
Intermec EasyCoder F2 – Installation & Operation Ed. 1
The pressure of the thermal printhead against the ribbon or paper is
factory adjusted. However, the use of thicker or thinner paper than
normal could require the printhead pressure to be readjusted.
Using a flat-tipped screwdriver, turn the adjustment screw clock-
wise for increased pressure (+), or counter-clockwise for less pres-
sure (-). Print a few labels, preferably test labels (see chapter 6 "Set-
ting Up the Printer"), and check the printout. Increased pressure
generally gives a darker printout and vice versa. Repeat until the
desired result is obtained.
To return to the factory setting, tighten the screw (+) as far as it goes
and then loosen it (-) eight (8) full turns.
Note!
Do not use a higher printhead pressure than necessary, because it
may increase the wear of the printhead and thus shorten its life.
Chapter 12 Adjustments
Adjustment Screw
84