At/Atx Power Mode Setting; Me Override Setting Jumper; Figure 3-3: At/Atx Power Mode Switch Locations; Table 3-4: At/Atx Power Mode Switch Pinouts - IEI Technology WAFER-JL-N5105 User Manual
3.5" sbc with intel 10nm jasper lake celeron n5105 processor with dual displays, ddr4, triple intel 2.5 gbe, usb3.2, m.2, sata, com, soc, rohs
Table of Contents
Advertisement
WAFER-JL-N5105 SBC
3.2.1 AT/ATX Power Mode Setting
CN Label:
CN Type:
CN Location:
CN Pinouts:
The AT/ATX power mode selection is made through the AT/ATX power mode switch which
is shown in Figure3-3.
Figure 3-3: AT/ATX Power Mode Switch Locations
PIN NO.
Short A - B
Short B – C
Table 3-4: AT/ATX Power Mode Switch Pinouts
3.2.2 ME Override Setting Jumper
CN Label:
CN Type:
CN Location:
CN Pinouts:
The ME_FLASH1 connector is used for Flash Descriptor Security Overide or ME Debug
Mode.
J_ATX_AT1
3-pin switch
See
Figure 3-3
787H
See Table 3-4
DESCRIPTION
ATX Power Mode (default)
AT Power Mode
ME_FLASH1
2-pin header,P=1.27mm
See
Figure 3-4
787H
See Table 3-5
Page 17
Advertisement
Table of Contents
