Figure 3-4: Me Override Setting Jumper Locations; Table 3-5: Me Override Setting Jumper Pinouts - IEI Technology WAFER-JL-N5105 User Manual

Figure 3-4: ME Override Setting Jumper Locations

PIN NO.
Open
Short

Table 3-5: ME Override Setting Jumper Pinouts

To update the ME firmware, please follow the steps below.
Step 1:
Before turning on the system power, short the Flash Descriptor Security
Override jumper.
Step 2:
Update the BIOS and ME firmware, and then turn off the system power.
Step 3:
Remove the metal clip on the Flash Descriptor Security Override jumper to its
default setting.
Step 4:
Restart the system. The system will reboot 2 ~ 3 times to complete the ME
firmware update.
Page 18
WAFER-JL-N5105 SBC
DESCRIPTION
Disable (default)
Enable