Table of Contents
Advertisement
Adjusting the TV-VVTZC-E2 driver properties
Specific Events
On these pages, you can enable/disable, change BACnet alarm properties, or set delays for the following BACnet
alarms:
Specific alarms:
•
Flow Control Alarm
•
Reheat Valve Alarm
NOTE To set up alarm actions for controller generated alarms, see Alarms in i-Vu® Help.
Controller Generated Alarm
Description
Events
Alarm Category and Alarm
Template
Enable
Notification Class
Custom Translation Tables
You can set up a translation table that an analog input will use to translate the raw data from a non-linear sensor
to the engineering units you want it to provide on the output wire of the Analog Input microblock. In the navigation
tree, select Custom Translation Table #1, #2, or #3. The Properties page has instructions.
For the input to use the translation table, go to the control program's Properties page > I/O Points tab. Click the
analog input in the Name column. On the Details tab, set Sensor Type (Scaling Method) to Non-Linear, Custom
Table #__.
BACnet Controller Properties
The BACnet Controller Properties page provides the following information plus the items described in the table
below:
•
The TV-VVTZC-E2's Ethernet MAC address
•
Whether Port S1 is being used for MS/TP and is disabled
NOTE The options shown on the page change according to your controller's settings.
TruVu™ VVTZC-E2
Installation and Start-up Guide
Short message shown on the i-Vu® Alarms page or in an alarm action when this
type of alarm is generated.
See Alarms in i-Vu® Help.
Clear these checkboxes to disable Alarm or Return to normal messages of this
type from this controller.
Do not change this field.
74
©2022 Carrier.
All rights reserved.
Advertisement
Table of Contents
Troubleshooting
