Table of Contents
Advertisement
To set up the driver
Specific Events
On these pages, you can enable/disable, change BACnet alarm properties, or set delays for the following BACnet
alarms:
Specific alarms:
•
Flow Control Alarm
•
Reheat Valve Alarm (future use)
NOTES
•
To set up alarm actions for controller generated alarms, see See Alarms in i-Vu® Help.
•
Reheat Valve Alarms are for future use.
Module Generated Alarm
Description
Events
Alarm Category and Alarm
Template
Enable
Notification Class
Switches, Jumpers, Options
The Switches, Jumpers, Options page shows the current physical settings on the Zone Ctrl II.
Flow Calibration Archive
The Flow Calibration Archive page shows measured flow and sensor readings that were entered in the i-Vu®
interface Test and Balance or through the stand-alone Airflow Test and Balance Utility. Editing Airflow microblock
properties outside of Test and Balance will not change the values on this page.
Zone Ctrl II and
VAV Zone II Secondary Duct Installation and Start-up Guide
Error! No text of specified style in document.
Short message shown on the i-Vu® Alarms page or in an alarm action when this
type of alarm is generated.
See Alarms in i-Vu® Help.
Clear these checkboxes to disable Alarm or Return to normal messages of this
type from this controller.
Do not change this field.
40
CARRIER CORPORATION ©2019
All rights reserved
Advertisement
Table of Contents
