Carrier TruVu VVTZC-E2 Installation And Startup Manual page 32

Wiring inputs and outputs
The TV-VVTZC-E2 has connections for one bus.
Verify that the TV-VVTZC-E2's power and communications connections work properly.
1
Turn off the TV-VVTZC-E2's power.
2
Connect the input wiring to the screw terminals on the TV-VVTZC-E2.
3
NOTE Connect the shield wire to the – terminal with the ground wire. Do not connect the shield wire at the
other end of the cable as this will cause a ground loop error.
TruVu™ VVTZC-E2
Installation and Start-up Guide
26
©2022 Carrier.
All rights reserved.