Wiring A Remote Occupancy Sensor; Wiring Equipment To Outputs - Carrier TruVu VVTZC-E2 Installation And Startup Manual

Wiring inputs and outputs

Wiring a remote occupancy sensor

You can wire a normally open or normally closed dry-contact occupancy sensor to the TV-VVTZC-E2's IN-04 input
and Gnd terminals as shown below. The controller supplies the voltage needed for the input.

Wiring equipment to outputs

Use the following wiring diagrams to wire zone terminal equipment to the TV-VVTZC-E2's outputs.
Single duct
Single duct 2-position hot water
Single duct modulating hot water
Single duct SCR electric heat
Single duct combination baseboard and ducted heat
Single duct staged electric heat
Fan box 2-position hot water
Fan box modulating hot water
Fan box SCR electric heat
Fan box combination base board and ducted heat
Fan box 2-stage electric heat
Wiring field-supplied actuators to the analog output (page 50)
WARNING Disconnect electrical power to the TV-VVTZC-E2 before wiring it. Failure to follow this warning
could cause electrical shock, personal injury, or damage to the controller.
TruVu™ VVTZC-E2
Installation and Start-up Guide
38
©2022 Carrier.
All rights reserved.