Specific Events; Custom Translation Tables - Carrier TruVu UCXP683T Installation And Startup Manual

Specific Events

On these pages, you can enable/disable, change BACnet alarm properties, or set delays for the following BACnet
alarms:
Specific alarms:
•
Flow Control Alarm
•
Reheat Valve Alarm
NOTE To set up alarm actions for controller generated alarms, see Alarms in i-Vu® Help.
Controller Generated Alarm
Description
Events
Alarm Category and Alarm
Template
Enable
Notification Class

Custom Translation Tables

Applies to the analog input of an attached expander.
You can set up a translation table that an analog input will use to translate the raw data from a non-linear sensor
to the engineering units you want it to provide on the output wire of the Analog Input microblock. In the navigation
tree, select Custom Translation Table #1, #2, or #3. The Properties page has instructions.
For the input to use the translation table, go to the control program's Properties page > I/O Points tab. Click the
analog input in the Name column. On the Details tab, set Sensor Type (Scaling Method) to Non-Linear, Custom
Table #__.
TruVu™ UCXP683T
Installation and Start-up Guide
Short message shown on the i-Vu® Alarms page or in an alarm action when this
type of alarm is generated.
See Alarms in i-Vu® Help.
Clear these checkboxes to disable Alarm or Return to normal messages of this
type from this controller.
Do not change this field.
37
Adjusting the TV-UCXP683T driver properties
CARRIER CORPORATION ©2022
All rights reserved