Specific Events
On these pages, you can enable/disable, change BACnet alarm properties, or set delays for the following
BACnet alarms:
Specific alarms:
•
Flow Control Alarm
•
Reheat Valve Alarm (future use)
NOTES
•
To set up alarm actions for controller generated alarms, see See Alarms in i-Vu® Help.
•
Reheat Valve Alarms are for future use.
Module Generated Alarm
Description
Events
Alarm Category and Alarm
Template
Enable
Notification Class
Switches, Jumpers, Options
The Switches, Jumpers, Options page shows the current physical settings on the VVT Bypass II.
Flow Calibration Archive
The Flow Calibration Archive page shows measured flow and sensor readings that were entered in the i-Vu®
Test and Balance tool.
VVT Bypass II Controller
Installation and Start-up Guide
Short message shown on the i-Vu® Alarms page or in an alarm action when this
type of alarm is generated.
See Alarms in i-Vu® Help.
Clear these checkboxes to disable Alarm or Return to normal messages of this
type from this controller.
Do not change this field.
33
To adjust the driver properties
CARRIER CORPORATION ©2019
All rights reserved