Bacnet Tab; Security Tab; Local Network Tab - Carrier TruVu VVTZC-E2 Installation And Startup Manual

Table of Contents

To set up the controller through the Comm/Service ports

BACnet tab

NOTE The TV-VVTZC-E2 can be configured for only one BACnet communication type.

On the BACnet tab, you can choose to run BACnet Over IP or BACnet Over Ethernet on the Eth0 and Eth1 ports.

If you choose BACnet Over IP, you can edit the BACnet UDP Port.

BACnet Firewall

Use the Local Network tab to:

•

Discover 256 i-Vu® XT or TruVu™ devices on a single network at a time.

•

Discover both configured or unconfigured devices on this controller's network.

•

See the number of devices discovered and the total number on the network.

•

Identify the i-Vu® XT or TruVu™ controller that has had its DSC button pressed.

•

Export the Local Devices that are present in the table (limited to 256) to a .csv file.

•

Set a device's Mode, Address, and Location.

•

Assign IP addresses to multiple devices at one time.

•

Prompt an LED to blink on a device.

A device that is new from the factory or has not been previously configured with an IP address, can always be

configured using the Local Devices table. However, once you have assigned a valid IP address, you have up to 24

hours to make any other changes. After 24 hours, the fields are not editable and the device is Locked.

You can unlock a device for 24 hours by either pressing the DSC button on the TV-VVTZC-E2 controller or by using

the i-Vu® application. In the i-Vu® navigation tree, right-click the TV-VVTZC-E2, select Driver Properties and go to

Driver > Settings tab > Local Network Configuration. Check Allow Local Network Configuration from other

devices on the local network for 24 hours and click Accept.

TruVu™ VVTZC-E2

Installation and Start-up Guide

If your BACnet Firewall configuration in the i-Vu® interface did not include the i-

Vu® server IP address, thus blocking communication with the i-Vu® server, you

can disable the controller's BACnet Firewall on the controller setup Security tab.

NOTE You can enable the BACnet Firewall only in the i-Vu® interface.

Table of Contents