Setting The Fm Rate; Turning On Frequency Modulation - HP ESG Series User Manual

Setting the FM Rate

1. In the same FM menu, press the
and the normal preset value for FM rate is displayed in the active entry area.
2. Enter 10 kHz using the numeric keypad and pressing the
new FM rate is displayed below the
the second line of the softkey.

Turning On Frequency Modulation

The signal generator is now configured to output a 0 dBm, frequency-modulated
carrier at 104.9 MHz with the FM deviation set to 75 kHz and the FM rate set to
10 kHz. The shape of the waveform is a sinewave (notice that sine is the default
for the softkey - press
FM Waveform
remaining steps to output the frequency-modulated signal.
1. In the same FM menu, press the
also, that the FM display annunciator is turned on indicating that you have enabled
frequency modulation.
2. Press the front panel RF On/Off
changes from RF OFF to RF ON. The modulated signal is now available at the RF
OUTPUT connector.
Setting Up Internally-Generated Frequency Modulation
softkey. FM rate becomes the active function
FM Rate
FM Rate softkey. You should see
to see the softkey). Follow these
More (1 of 2)
softkey. FM toggles from
FM Off On
key to toggle RF on. Notice that the display annunciator
Using Functions
kHz terminator softkey. The
10.0000 kHz
to . Notice,
Off On
in
2-9