Ext 1 Ac-Coupled - HP ESG Series User Manual

Ext 1 AC-Coupled

This softkey lets you input an external, AC-coupled, amplitude modulation signal
to the EXT 1 INPUT connector. The modulation signal is tested for voltage and a
display annunciator will report a high or low condition if the voltage is >
1 Vpk.
The external 1 input has multiple uses but can be used for only one modulation at
a time. If, for example, you were using the external 1 input in a frequency
modulation configuration for
also use the external 1 input, the signal generator would turn off
assign the external 1 input to your
this discussion, the external 1 AC-coupled input is the same as the external 1
DC-coupled input.)
Softkey Location: Press
Status after Normal Preset: AM Source is set to Internal
SCPI Commands:
[:SOURce]:AM[1]|2:SOURce EXTernal1
[:SOURce]:AM[1]|2:EXTernal[1]:COUPling AC
[:SOURce]:AM[1]|2:EXTernal[1]:COUPling?
, and then you configured
FM Path 1
configuration. (For the purpose of
AM Path 2
, ,
AM AM Source Ext 1 AC-Coupled
Hardkey and Softkey Reference
±
3% of
AM Path 2
and
FM Path 1
AM
to
5-13