Lf Out Start Freq - HP ESG Series User Manual

LF Out Start Freq

Hardkey and Softkey Reference
LF Out
Use this softkey to change the starting frequency for swept-sine low frequency
output. To change the value, press the softkey once. The current value for the LF
Out start frequency is displayed in the active entry area. To enter a new value,
rotate the front panel knob until the desired value is displayed, use the up and
down arrow keys, or enter the value using the numeric keypad and press the
terminator softkey. The range of values allowed is 0.1 Hz to 50 kHz. The
kHz
minimum increment allowed is 0.1 Hz.
This softkey is coupled to the
the softkey in the LF Out Dual-Sine Menu. Any value set for
LF Out Tone 1 Freq
is reflected in the
LF Out Start Freq
Conversely, if you change the value for either the
softkey, the value for
LF Out Tone 1 Freq
This softkey is only active when you have selected the internal source to operate
as a function generator.
Softkey Location: Press
,
LF Out Waveform Swept-Sine
Status after Normal Preset: 400.0 Hz
SCPI Commands:
[:SOURce]:LFOutput:FUNCtion:FREQuency <val><unit>
[:SOURce]:LFOutput:FUNCtion:FREQuency?
5-74
softkey in the initial LF Out Menu and
LF Out Freq
and
LF Out Freq
LF Out Start Freq
, ,
LF Out LF Out Source
,
LF Out Start Freq
LF Out Tone 1 Freq
softkey or the
LF Out Freq
is changed to match.
,
Function Generator
or
Hz
softkeys.