HP ESG Series User Manual page 90

ESG Series Signal Generator Instrument-Specific Error Messages
605
DSP FW download failed.
Indicates that the instrument's firmware was unable to
successfully initialize the internal DSP. Report the
circumstances to the nearest HP Sales and Service office.
606
DSP times out.
Indicates that the DSP failed to respond within the appropriate
amount of time. Report the circumstances to the nearest HP
Sales and Service office.
607
DSP returns error.
Indicates that the DSP is in an indeterminate state. Report the
circumstances to the nearest HP Sales and Service office.
608
DSP in use by other process.
Indicates that the DSP is in an indeterminate state. Report the
circumstances to the nearest HP Sales and Service office.
615
New wave shape changes limit for internal
frequency;frequency changed to new limit.
When using the internal modulation source, the upper limit
varies for the different waveforms. If the user changes the
waveform when the internal source frequency is higher than
that allowed for the new waveform, the frequency for the
source will be changed, and the user informed of that change
with this message.
617
Configuration error; Data Generator Memory
configuration does not match installed board.
This indicates that the memory configuration for an option
board does not match the known memory limits of the board. If
this error has occurred as the result of a customer-installed
option, uninstall all options and then reinstall the correct
options. If the error persists, contact the factory.
Configuration error; Installed option boards do
not match configuration information.
This indicates that the option boards have not been properly
installed in the instrument. Verify that the correct option boards
have been installed in the correct slots. Reinstall the correct
option. If the error persists, contact the factory.
Troubleshooting
3-47