Ampl; Ampl Start - HP ESG Series User Manual

Ampl

Ampl Start

Hardkey and Softkey Reference
Sweep/List
Press this softkey to set the signal generator to sweep amplitude data only. The
frequency is set at a constant value determined by the
You can define a sweep containing both amplitude and frequency information and
still choose to sweep amplitude only.
Softkey Location: Press
Status after Normal Preset: Sweep is set to Off
SCPI Commands:
[:SOURce]:POWer:MODE LIST
[:SOURce]:POWer:MODE?
Press this softkey to set the amplitude of the first point in the sweep. You can set
the value anywhere in the range of the signal generator's specified output power.
Press and amplitude becomes the active function for the first point in
Ampl Start
the sweep. To enter the value, rotate the front panel knob until the desired value is
displayed, use the up and down arrow keys, or enter the value using the numeric
keypad and press the
dBm
softkey.
Softkey Location: Press
Status after Normal Preset:
SCPI Commands:
[:SOURce]:POWer:STARt <val><unit>
[:SOURce]:POWer:STARt?
5-148
, ,
Sweep/List Sweep Ampl
, , , ,
dBuV dBuVemf mV
,
Sweep/List Configure Step Sweep
−
135 dBm
front panel key.
Frequency
, , or terminator
uV mVemf uVemf
,
Ampl Start