Trigger Out Polarity Neg Pos - HP ESG Series User Manual

Trigger Out Polarity Neg Pos

Hardkey and Softkey Reference
AM
This softkey toggles the polarity of the TTL signal that is output at the rear panel
TRIGGER OUT connector. When
output signal is asserted high (+5 V) at the start of the swept-sine amplitude
modulation sweep and low (0 V) when the sweep is concluded. Setting
Trigger Out Polarity Neg Pos
low is +5 V.
This softkey is coupled to the
Φ
swept-sine FM, M, and LF Out menus and the sweep/list menu. When the
polarity is toggled for this softkey in any one of these menus, it affects all
locations of the softkey.
Softkey Location: Press
Trigger Out Polarity Neg Pos
Status after Normal Preset: Pos
SCPI Commands:
:TRIGger:OUTPut:POLarity POSitive|NEGative
:TRIGger:OUTPut:POLarity?
5-20
Trigger Out Polarity Neg Pos
to reverses the polarity, where a high is 0 V and a
Neg
Trigger Out Polarity Neg Pos
, ,
AM AM Waveform Swept-Sine
is set to , the
Pos
softkey in the
,