HP ESG Series User Manual page 84

Troubleshooting
ESG Series Signal Generator Instrument-Specific Error Messages
Out of memory;Unable to display format window.
Indicates that the instrument was unable to create part of the
graphical user interface due to an inability to allocate memory
(possibly due to fragmentation). Please report the
circumstances to the factory. The instrument is still functional.
Out of memory;Cannot uncompress file.
Indicates that a file cannot be uncompressed because
STATE:
there is not enough memory to run the decompression
algorithm. Recall will fail and there will be no instrument state
change. Reduce the size of any sweep lists and try again.
Out of memory;Cannot precalculate frequencies.
Try fewer frequencies.
Indicates that memory was exhausted during frequency
precalculation (used to speed the process of sweep/list mode).
List mode cannot run until either fewer frequencies have been
supplied or more memory becomes available and the same set
of frequencies are sent again, is executed, or
FREQ:MODE CW
is executed.
:FREQ:MODE LIST
Out of memory;Object Memory Area
Indicates that memory was exhausted during instrument
power-on. Report the circumstances to the factory.
Out of memory;List formation
The device was unable to allocate space for a lookup table, such
as for list mode precalculation. List mode cannot run until
either fewer frequencies have been supplied or more memory
becomes available and the same set of frequencies are sent
again, is executed, or is
FREQ:MODE CW :FREQ:MODE LIST
executed.
Out of memory;Display system out of memory. An
abnormal display may result. Memory consumption
should be reduced.
There was not enough memory in the system to properly update
the display. Some inconsistencies may be seen. The size of any
list/sweep should be reduced, and the source should be preset to
clear up any inconsistencies. Report the circumstances to the
nearest HP Sales and Service office.
3-41