Φ M Path 1 - HP ESG Series User Manual

Φ
M Path 1 2
Φ Φ
Use and
M Path 1 M Path 2
configurations. For example, select
Φ
normal preset. If
M Path 1
selection will toggle from
characteristics (such as deviation, source, rate, and waveform) using the
remaining softkeys in the
To configure a second phase modulation configuration, toggle to
Define the modulation characteristics for this second configuration and enable
Φ Φ
M by setting
M Off On
The RF carrier is available at the RF OUTPUT connector when you set
to . Set
On Mod On/Off
you have enabled.
Φ Φ
and
M Path 1 M Path 2
path can be switched to any one of the modulation sources: Int, Ext1, or Ext2. All
modulation types can be simultaneously enabled, except FM with
Φ
and M can sum simultaneous inputs from any two sources (Int, Ext1, and Ext2).
Any given source (Int, Ext1, or Ext2) can only be routed to one activated
modulation type.
Softkey Location: Press
Φ
M Path 1 2
Status after Normal Preset:
to define two unique phase modulation
Φ
M Path 1
is not highlighted, press the softkey once and the
Φ Φ
to
M Path 2 M Path 1
Φ
M menu. Then enable
to .
On
to to modulate the RF carrier with the modulations that
On
are summed internally for composite modulation. Either
Φ
hardkey, toggle
FM/ M
Φ
M Path 1
Hardkey and Softkey Reference
Phase Modulation
Φ
( is the default after a
M Path 1
.) Configure the modulation
Φ Φ
M by setting
M Off On
Φ
M Path 2
Φ
M. AM, FM,
Φ Φ
softkey to
FM/ M M
to .
On
.
RF On/Off
, press
5-99