Φ M Start Rate - HP ESG Series User Manual

Φ
M Start Rate
Hardkey and Softkey Reference
Phase Modulation
Use this softkey to change the starting internal modulation frequency for
swept-sine phase modulation. To change the value, press the softkey once. The
Φ
current value for the M start rate is displayed in the active entry area. To enter a
new value, rotate the front panel knob until the desired value is displayed, use the
up and down arrow keys, or enter the value using the numeric keypad and press
or terminator softkey. The range of values allowed is 0.1 Hz to 50 kHz.
the
Hz kHz
The minimum increment allowed is 0.1 Hz.
This softkey is coupled to the
Φ
softkey in the
M Tone 1 Rate
Φ
is reflected in the
M Start Rate
Conversely, if you change the value for either the
Φ
softkey, the value for
M Tone 1 Rate
Softkey Location: Press
Φ
,
More (1 of 2) M Waveform
Status after Normal Preset: 400.0 Hz
SCPI Commands:
[:SOURce]:PM[1]|2:INTernal[1]:FREQuency <val><unit>
[:SOURce]:PM[1]|2:INTernal[1]:FREQuency?
5-102
Φ
softkey in the initial
M Rate
Φ
M Dual-Sine Menu. Any value set for
Φ Φ
and
M Rate M Tone 1 Rate
Φ
M Start Rate
Φ
hardkey, toggle
FM/ M
Φ
, ,
Swept-Sine M Start Rate
Φ
M Menu and the
softkeys.
Φ
softkey or the
M Rate
is changed to match.
Φ Φ
softkey to , press
FM/ M M