Φ M Sweep Trigger; Φ M Tone 1 Rate - HP ESG Series User Manual

Φ
M Sweep Trigger
Φ
M Tone 1 Rate
Hardkey and Softkey Reference
Phase Modulation
Pressing this softkey reveals a menu of choices for triggering swept-sine phase
modulation. You can choose triggering that occurs immediately, triggering that is
supplied by the HP-IB, triggering on either the positive or negative edge of a
signal supplied to the TRIGGER IN connector, or triggering by the front panel
key.
Trigger
Softkey Location: Press
Φ
,
More (1 of 2) M Waveform
Status after Normal Preset: Immediate
SCPI Commands:
:TRIGger[:SEQuence]:SOURce?
Press this softkey to set the internal modulation frequency for the
Enter the desired rate using the up and down arrow keys, the front panel knob, or
enter a value using the numeric keypad and press the
The range of values allowed is 0.1 Hz through 50 kHz. The minimum increment
allowed is 0.1 Hz.
This softkey is coupled to the
Φ
softkey in the
M Start Rate
Φ
is reflected in the
M Tone 1 Rate
Conversely, if you change the value for either the
Φ
softkey, the value for
M Start Rate
Softkey Location: Press
Φ
,
More (1 of 2) M Waveform
Status after Normal Preset: 400.0 Hz
SCPI Commands:
[:SOURce]:PM[1]|2:INTernal[1]:FREQuency <val><unit>
[:SOURce]:PM[1]|2:INTernal[1]:FREQuency?
5-104
Φ
hardkey, toggle
FM/ M
Φ
, ,
Swept-Sine M Sweep Trigger
Φ
softkey in the initial
M Rate
Φ
M Swept-Sine Menu. Any value set for
Φ Φ
and
M Rate
Φ
M Tone 1 Rate
Φ
hardkey, toggle
FM/ M
Φ
, ,
Dual-Sine M Tone 1 Rate
Φ Φ
softkey to , press
FM/ M M
Φ
M tone 1.
or terminator softkey.
kHz Hz
Φ
M Menu and the
softkeys.
M Start Rate
Φ
softkey or the
M Rate
is changed to match.
Φ Φ
softkey to , press
FM/ M M