Lf Out Width; Noise - HP ESG Series User Manual

LF Out Width

Noise

Hardkey and Softkey Reference
LF Out
Use this softkey to change the pulse width for the pulsed low frequency
waveform. To change the width, press the softkey once. The current value for
pulse width is displayed in the active entry area. To enter a new value, rotate the
front panel knob until the desired value is displayed, use the up and down arrow
keys, or enter the value using the numeric keypad and press the
terminator softkey. The range of values allowed is from 8
value for the pulse period.
This softkey is only active when you have selected the internal source to operate
as a function generator and when the LF Out waveform is specified as pulse.
Softkey Location: Press
,
LF Out Waveform More 1 of 2
Status after Normal Preset: 40
SCPI Commands:
[:SOURce]:LFOutput:FUNCtion:PWIDth <val><unit>
[:SOURce]:LFOutput:FUNCtion:PWIDth?
This softkey lets you specify noise as the waveform for the LF output signal.
This softkey is only active when you have selected the internal source to operate
as a function generator.
Softkey Location: Press
,
LF Out Waveform More 1 of 2
Status after Normal Preset: LF Out Waveform is set to Sine
SCPI Commands:
[:SOURce]:LFOutput:FUNCtion:SHAPe NOISe
[:SOURce]:LFOutput:FUNCtion:SHAPe?
5-80
, ,
LF Out LF Out Source
, ,
Pulse LF Out Width
µ
s
, ,
LF Out LF Out Source
,
Noise
µ
or
sec
µ
s to a maximum of the
,
Function Generator
,
Function Generator
msec