Trigger Out Polarity Neg Pos - HP ESG Series User Manual

Trigger Out Polarity Neg Pos

SCPI Commands:
[:SOURce]:LIST:TRIGger:SOURce KEY
[:SOURce]:LIST:TRIGger:SOURce?
This softkey toggles the polarity of the TTL signal that is output at the rear panel
TRIGGER OUT connector. When
output signal is asserted high (+5 V) at the start of a dwell sequence, or at the start
of waiting for the point trigger, and low (0 V) when the dwell is over, or when the
point trigger is received. Setting
polarity where a high is 0 V and a low is +5 V.
This softkey is coupled to the
Φ
swept-sine AM, FM,
this softkey in any one of these menus, it affects all locations of the softkey.
Softkey Location: Press
Status after Normal Preset: Pos
SCPI Commands:
:TRIGger:OUTPut:POLarity POSitive|NEGative
:TRIGger:OUTPut:POLarity?
Trigger Out Polarity Neg Pos
Trigger Out Polarity Neg Pos
Trigger Out Polarity Neg Pos
M, and LF Out menus. When the polarity is toggled for
,
Sweep/List More (1 of 2)
Hardkey and Softkey Reference
is set to
to reverses the
Neg
softkey in the
,
Trigger Out Polarity Neg Pos
Sweep/List
the
Pos
5-165