Φ M Stop Rate; M Sweep Time - HP ESG Series User Manual

Φ
M Stop Rate
Φ

M Sweep Time

Use this softkey to change the ending internal modulation frequency for
swept-sine phase modulation. To change the value, press the softkey once. The
Φ
current value for the
new value, rotate the front panel knob until the desired value is displayed, use the
up and down arrow keys, or enter the value using the numeric keypad and press
the or terminator softkey. The range of values allowed is 0.1 Hz to 50 kHz.
Hz kHz
The minimum increment allowed is 0.1 Hz.
This softkey is coupled to the
Φ
Any value set for
M Stop Rate
Conversely, if you change the value for the
Φ
is changed to match.
M Stop Rate
Softkey Location: Press
Φ
,
More (1 of 2) M Waveform
Status after Normal Preset: 400.0 Hz
SCPI Commands:
[:SOURce]:PM[1]|2:INTernal[1]:FREQuency:ALTernate <val><unit>
[:SOURce]:PM[1]|2:INTernal[1]:FREQuency:ALTernate?
Press this softkey to set the sweep time for swept-sine phase modulation. The
signal generator will vary the
in the time set with this softkey. Enter the desired sweep time using the up and
down arrow keys, the front panel knob, or enter a value using the numeric keypad
and press the or
sec msec
through 65.535 s. The minimum increment allowed is 1 ms.
Softkey Location: Press
Φ
,
More (1 of 2) M Waveform
Status after Normal Preset: 100.0 msec
SCPI Commands:
[:SOURce]:PM[1]|2:INTernal[1]:SWEep:TIME <val><unit>
[:SOURce]:PM[1]|2:INTernal[1]:SWEep:TIME?
M stop rate is displayed in the active entry area. To enter a
Φ
M Tone 2 Rate
is reflected in the
Φ
Φ
hardkey, toggle
FM/ M
Φ
, ,
Swept-Sine M Stop Rate
Φ
M rate from the specified start rate to the stop rate
terminator softkey. The range of values allowed is 1 ms
Φ
hardkey, toggle
FM/ M
Φ
, ,
Swept-Sine M Sweep Time
Hardkey and Softkey Reference
Phase Modulation
Φ
softkey in the M Dual-Sine Menu.
Φ
softkey.
M Tone 2 Rate
softkey, the value for
M Tone 2 Rate
Φ Φ
softkey to
FM/ M
Φ Φ
softkey to
FM/ M
, press
M
, press
M
5-103